SECTION 3 -
SERVICING AND CONVERSION
Important
BEFORE ATTEMPTING ANY SERVICING, ENSURE
ISOLATING COCK IS TURNED OFF AND CANNOT BE
INADVERTENTLY
TURNED
ON.
AFTER
ANY
MAINTENANCE TASK, CHECK APPLIANCE TO
ENSURE THAT IT PERFORMS CORRECTLY AND
CARRY OUT ANY NECESSARY ADJUSTMENTS AS
DETAILED IN SECTION 1.
After carrying out any servicing or exchange of gas
carrying component.
ALWAYS CHECK FOR GAS TIGHTNESS!
3.1 GAS CONVERSION CHECK LIST
For All Appliances
CHANGE INJECTORS
CHANGE BY-PASS SCREW AND SET LOW RATE .
Refer to Section 1.10.
CHANGE DATA PLATE
Ensure gas supply is disconnected before commencing.
Only reconnect gas supply after all conversion work has
been completed.
Natural to Propane
Remove governor from appliance inlet pipe-work.
Propane to Natural
Fit governor to appliance inlet pipe-work and follow
details in Section 2.5.
3.1.2 Open Top Low setting
Screw - To Replace
(Figure 7)
a) Remove control panel.
b) Unscrew and remove existing low position screw
from open top tap.
c) Insert replacement screw into open top tap and
secure. Repeat for all taps.
d) Refit control panel.
3.1.3 Oven Burner - To Replace Injector
a) Remove oven shelves and base plate.
b) Disconnect Gas supply pipe.
c) Unscrew and remove existing injector.
d) Insert and screw in replacement injector.
e) Re-connect Gas supply pipe.
3.1.4 Thermostat - To Replace Bypass Screw
(Figure 7)
a) Remove control panel.
b) Unscrew and remove existing bypass screw from
thermostat.
c) Insert replacement bypass screw and secure into
thermostat.
d) Re-assemble in reverse order.
3.1.1 Open Top Burners - To Replace Injector
(Figure 8)
a) Remove pan supports.
b) Remove burner heads and burner bezels.
c) Remove pressed hob by pulling upwards.(Do not
remove screws in hob.)
d) Leaving injector holders in situation, unscrew existing
injectors.
e) Remove injectors.
f ) Insert replacement injectors and secure. Repeat for all
taps
g) Refit removed parts.
Open top low setting
screw
Thermostat bypass screw
Figure 7
Open top injector
Figure 8
