SECTION 2 - ASSEMBLY and
COMMISSIONING
Fixings
2.1 ASSEMBLY
Note
The following paragraphs should be read as applicable
to the unit being assembled.
a) Unpack appliance and place it in position using feet
adjusters to level appliance.
b) Units with castors should be fitted with accessories
supplied according to separate instructions provided.
c) Open oven door, pull out shelves and base panel.
Check burner spark igniter arrangements are correctly
located and secured. Ensure ALL packing, etc. is
removed from oven. Replace all parts in reverse
sequence.
d) Check open top and remove tape, packing, etc. from
hob area and ensure that all burners and pan supports
are secured in position. The open top burner heads fit
loosely upon aluminium bases of lift-off construction.
2.1.1 Fryplate Accessory
If fryplate (Figure 2) is supplied, refer to user instructions
for details. Important note: this should be operated on a
low flame setting only.
2.1.2 Flue Accessory
A tall flue is available as an accessory that may be
substituted for standard type supplied with unit.
Details of the alteration process are indicated in Figures
3 through 6.
Remove hob as detailed in Sections 3.2.2 and 3.2.3.
Undo and remove fixings at locations shown in Figure 3.
Remove fixings at rear detailed in Figure 4.
Install replacement flue as detailed in Figure 5
and secure using existing fixings at hob and rear at
positions indicated in Figures 5 and 6.
Important Note: It is not possible to fit a
splashplate / plateshelf to a unit fitted with a tall flue.
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Fixings
Fixings
Fixings
