28
USAGE
GB
F- Accessories -
Insert the floor nozzle (or the sofa
nozzle) on the extension tubes. Connect the sprayer tube
to the pin of the extension tubes (push and turn
anti-clockwise).
Spray Extraction of
Carpeted Floors
A-
After desired accessory has been
selected and installed, proceed as follows:
• Unwind the mains lead and insert the plug into the power
point.
• Set the control switch to maximum suction power.
• Switch on the appliance by lightly pressing the ON/OFF
switch.
• Start the pump by the applying light
pressure to the switch.
B- Method of Operation
C-
Place the carpet spray extraction nozzle on the floor,
pull the lever of the metering valve and move the nozzle
blowly to the rear across the carpet at the same time.
In this way the deaning solution is sprayed under pressure
onto the dirty area and is immediately sucked up again
together with the dirt. To move the nozzle in a forward
direction, release the valve lever and lift the nozzle clear of
the carpet. The entire area is covered by cleaning adjacent
strips.
D- Float Valve -
When the liquid in the tank reaches the
maximum level, the float valve will automatically close the
intake aperture in the hood, interrupting the intake process.
Switch the appliance off immediately and withdraw the
mains plug. Open the dirty water discharge cap then pour
the dirty water inside the tank.
NOTE!
If, temporarily no spray extraction liquid is needed:
switch off the pump.
