30iE - v1111 - Installation/Operation - (9/48)
2.2.1.2 Incremental mode
Set the dro in incremental mode. ABS LED off
First method:
Presetting incremental zero after each drill.
Starting at point A.
Move the axis until the display reads [14.000] (B position) and drill the hole.
Set the X axis to zero. See note.
Move the axis until the display reads [23,000] (C position) and drill the hole.
Sets the X axis to zero. See note.
Move the axis until the display reads [25,000] (D position) and drill the hole.
Note:
If installation parameter PAR11=1, just press the axis key, ([X]) in this case, to zero
the axis.
Second
method:
Presetting the relative distance with respect to the next hole.
Starting at point A
Preset the relative distance to the next hole. See note.
Move the axis until the display reads [0.000] (B position) and drill the hole.
Preset the relative distance to the next hole. See note.
Move the axis until the display reads [0.000] (C position) and drill the hole.
Preset the relative distance to the next hole. See note.
Move the axis until the display reads [0.000] (D position) and drill the hole.
Notes:
If installation parameter PAR11=1, the presetting sequence is:
[ENTER]
[axis] [value]
[ENTER]
.
Switching over to
[ABS]
mode, displays the distance to part zero (datum).
The
calculator
function can also be used to preset an axis with the result of the
calculation. See section
Calculator on page 22
.
“ABS” off
(B) [14.000]
(C) [23,000]
(D) [25,000]
-14
(B) [0.000]
-23
(C) 0.000
-25
(D) [0.000]
