30iE - v1111 - Installation/Operation - (8/48)
2.2.1 Example
We will drill the holes of the following part as moving examples in incremental and
absolute modes.
First, set the dat um point on the part to be machined as described in the section
"Datum point (part zero) to work with tool compensation" on page 12
.
The axis must be positioned without tool compensation (canceled) because the hole
coordinates are referred to the center and no tool radius compensation is needed.
2.2.1.1 Absolute mode
Set the dro in absolute mode
Move the axis until the display reads [14.000] (B position) and drill the hole.
Move the axis until the display reads [37,000] (C position) and drill the hole.
Move the axis until the display reads [62,000] (D position) and drill the hole.
The displayed position value is always referred to the preset part zero (datum).
B
C
A
D
ABS
(B) [14.000]
(C) [37.000]
(D) [62.000]
