Fagor CNC8 070, Список кодов ошибок

Страница: 81 / 134

CNC8070
R
EF
. 0402
E
RROR SOLUTIONS
Page 75 of 128
Errors 1000-1999
1860 'Program K = 0/1/2'
DETECTION Executing the #PROBE 3 cycle (surface measuring cycle).
CAUSE Parameter K only admits the values 0, 1, 2.
SOLUTION Parameter K defines the axis to be used to measure the surface. Assign to K one of
the following values:
• 0 for the abscissa axis.
• 1 for the ordinate axis.
• 2 for the longitudinal axis.
1861 'The safety distance B must be greater than zero'
DETECTION Execution of the calibration or measuring cycle (#PROBE).
CAUSE Parameter B has been programmed with a negative value.
SOLUTION Assign a positive value.
1862 '#PROBE 1: not allowed when G20 is active'
DETECTION Executing the #PROBE 1 cycle.
CAUSE When starting the probe calibration cycle, G20 is active.
SOLUTION Program G17 (XY plane), G18 (ZX plane) or G19 (YZ plane) before calling the cycle.
1863 'Tool worn out'
DETECTION Execution of the tool calibration cycle #PROBE1.
CAUSE The cycle has detected a tool that is worn out. The measured tool wear is greater than
the allowed tolerance (parameter L or M).
SOLUTION Change the tool and execute the cycle again.
1864 '#PROBE 1: Parameters U, V, W must be greater than X, Y, Z'
DETECTION Execution of the tool calibration cycle #PROBE1.
CAUSE In the cycle, the coordinates defining the position of the probe have been defined
wrong. UVW are the top coordinates and XYZ are the bottom coordinates.
SOLUTION Assign the parameters so U > X, V > Y, W > Z.
1865 'Pocket with islands: Roughing T missing'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE The tool number (T) programmed in the roughing operation does not exist in the tool
table.
SOLUTION Insert the tool in the table or program another tool number that is in the table.
1866 'Pocket with islands: Wrong roughing F'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE The machining feedrate (F) programmed for the roughing operation has a value of 0.
SOLUTION Program F with a value other than 0.
1867 'Pocket with islands: Wrong roughing S'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE The spindle speed (S) programmed for the roughing operation has a value of 0.
SOLUTION Program S with a value other than 0.
1868 'Pocket with islands: Finishing T missing'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE The tool number (T) programmed in the finishing operation does not exist in the tool
table.
SOLUTION Insert the tool in the table or program another tool number that is in the table.
1869 'Pocket with islands: Wrong finishing F'
DETECTION Execution of a 2D or 3D pocket cycle with islands.
CAUSE The machining feedrate (F) programmed for the finishing operation has a value of 0.
SOLUTION Program F with a value other than 0.