Fagor CNC 8070, Руководство по программированию

Страница: 319 / 556

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡
Programming manual
CNC 8070
CYCLE EDI
T
OR
3D po
cket
12.
(S
OFT
V02.0
X
)
285
Geometric parameters:
The composition of the pocket and the plane and depth profiles are
stored in \ Cnc8070\ Users\ Profile.
pocket .P3D Pocket composition.
profile .PXY Plane profile.
profile .PXZ Depth profile.
P.Z1 P.Z2 P.Z3 P.Z4
Name of the depth profiles.
They corresponds to the first 4 contours defined in the surface
profile, the number indicates the order.
To define the depth profile, use one of the axis of the plane and
the perpendicular axis.
Use the same point to define the beginning of the contour and
the beginning of the depth contour.
For the outside contour, one for the surface (1).
For the islands, one for the base (2).
All the profiles must be open and without direction changes
along their travel (not zigzagging).
Vertical depth profiles for the outside contour and for the islands
that reach the surface plane need not be programmed.
P.3D Name of the 3D pocket.
Once the pocket configuration has been validated, the CNC
associates the geometry of the pocket to its name (surface
profile and depth profiles).
P.XY Name of the surface profile or plane profile.
It must indicate all the contours.
For the outside contour, the one for the surface (1).
For the islands, the one for the base (2).
All the contours must be closed and must not intersect
themselves.
Remember that the order in which the contours are defined is
very important.