Fagor CNC 8070, Руководство по программированию

Страница: 529 / 556

‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡ ‡
Programming manual
CNC 8070
PROBI
N
G CANNED
CYCLES.
Tool
cal
ib
rat
io
n
16.
(S
OFT
V02.0
X
)
495
X, U, Y, V, Z, W
Optional parameters.
After ending the cycle
Once the calibration cycle has ended
It updates global arithmetic parameters P298, P299 and the values
assigned to the tool offset selected in the tool table.
If the dimension of each edge was requested (parameter "N"), the
lengths will be assigned to global arithmetic parameters P271 and the
following ones, and the radii to global arithmetic parameters P251 and
the following ones.
S Tool direction and turning speed. The chosen direction must
be opposite to the cutting direction (Positive if M3 and negative
if M4).
If not programmed, the cycle assumes the value "S0"
(calibration with spindle stopped).
M Maximum radius wear allowed.
If not programmed, the cycle assumes the value "M0" (the tool
will not be rejected due to length wear).
C Behavior when exceeding the maximum wear allowed.
Value Meaning
0 It shows a message of rejected tool and stops the cycle.
1 The cycle replaces the tool with another one of the same
family.
If not programmed, the canned cycle will take the value of "C0".
N Number of cutting edges to be measured; The "S" parameter
must be defined with a value other than zero.
If not programmed, the cycle assumes the value "N0" (one
single measurement).
P298 Measured radius - previous radius (R+RW).
P299 Measured length - previous length (L+LW).
R Measured radius.
L Measured length
RW 0
LW 0