Facina_VKPCCTV_Instructions_Rev01
25
•
Press
[UP]
or
[DN]
then
[M]
button repeatedly to set the
LNG
coordinate value until complete.
•
Once it is done, the word
SET
will be blinking. Press and hold
[M]
button 2 seconds to exit.
Setting up the camera in the field
Once all program settings have been setup properly, your
camera is ready for field use.
Getting started
Listed below are some helpful suggestions on how to use your
camera to get the best result.
•
Mount the camera about 1.5~2M (5~6 feet) high with the
camera pointed at a slightly downward angle.
•
Mount the camera facing north or south
NOT
east or west
due to the rising and setting of the sun could produce
false triggers and overexposed images.
•
If you’re covering a trail, face the camera down or up the
trail. Most commercial cameras take less than one second
to sense motion/heat and take a picture.
•
Clean out any brush or weeds in front of camera. This will
cause false pictures caused by wind or in high
temperature days.
•
Double check battery before turning on the camera for
use.
•
Make sure to insert the memory card after setting up the
camera.