Fac S220, Руководство по эксплуатации и обслуживанию

Страница: 42 / 70

40
EN
TAKING THE SLICER OUT OF SERVICE
11
.1 - Correct procedure
A machine compromises:
• Aluminium-alloy frame.
• Stainless-steel inserts and components.
• Electrical parts and electrical cables.
• Electrical motor
• Plastics, etc.
- When commissioning third parties to perform dismantling and demolition, only
businesses authorised to dispose of these materials should be employed.
- When demolishing without outside assistance, sort the various types of material and
hand over to authorised businesses for disposal..
ALWAYS comply with the current legislation of the country in which the
slicer is utilised.
☞
WARNING: ALWAYS consult the manufacturer or authorised
service staff as regards removal and disposal of the blade (11)
so that this can take place in complete safety.
DO NOT ABANDON SCRAPS AS THEY ARE A SERIOUS
DANGER FOR PEOPLE, ESPECIALLY CHILDREN, AND
ANIMALS.
--------------------------
Refer to the “Instructions for treatment at the end of life” on page 12.
41
EN
PROBLEM CAUSES SOLUTION
Pressing the green or white
button the machine will not
start.
No power supply. Check that the plug is
properly inserted.
Defective electrical control
circuit. Call technical assistance.
The machine will not start,
and you hear a continuous
noise like a buzz (only
machines with three-phase
motor). The motor is functioning
single- phase. Immediately press the
stop button (red) and have
checked the power supply
cable and the circuits
upstream by qualified
personnel.
TROUBLESHOOTING
• The following information is intended to aid in identifying and correcting defects and
faults that may occur during use of the machine.
☞
Some failures can be resolved by the user; others require
precise technical skills or special skills, and must be carried
out by qualified personnel with recognized expertise and
experience in the specific area of intervention.
Do not disassemble the internal parts of the slicer. The
manufacturer declines all responsibility for any damage
caused by tampering.
– - - - - - - - – - - - - - - - – - - - - - - - – - - - - - - - – - - - - - - - – - - - - - - - – - - - - - - -
• The table below shows the most common problems that occur during the use of the
slicer and the operations required to eliminate the possible causes.
> > > >