Fac S220, Руководство по эксплуатации и обслуживанию

Страница: 38 / 70

36
180°
Fig. 20
EN
EXECUTION OF THE SHARPENING
9
.2 - Versions with built-in sharpener
WARNING: Cutting hazard! Use protective cut- and tear-
resistant gloves and perform all operations with extreme care.
PAY ATTENTION AT ALL TIMES!
The blade sharpening should be performed periodically, as soon as you feel a decrease
in the ability of cutting blade, it should follow the instructions below:
1. Carefully clean the blade (11) c with denatured alcohol to degrease it after
disconnecting the plug from the socket;
2. Loosen the knob (20a), lift and rotate 180° the sharpener (20) and insert the wheels
on the slicer’s blade. Tighten the knob (20a);
20a
20a
20
20
11
20
20
20
11
11
11
37
Fig. 21
Fig. 22
30÷40 sec.
3÷4 sec.
EN
EXECUTION OF THE SHARPENING
3. Trigger the switch (1) and press the little button (x2);
4. Allow the blade to rotate for about 30 to 40 seconds and then use the switch to stop
it checking with a slight shift (using a pencil) to the outside of the blade if the burr is
formed.
We reccomend to perform this check very carefully as
the blade is very sharp.
5. Ascertained the formation of the burr, trigger the switch again (1) for 3/4 seconds
pressing the little buttons at the same time (x2 and x3);
☞
DO NOT PROLONG THIS OPERATION BEYOND THE FEW
ABOVEMENTIONED SECONDS TO PREVENT THAT THE
BLADE EDGE WILL TWIST.
x2
x3
x2