FabWeaver A530, Руководство пользователя

Страница: 74 / 120

Print
3
-4
3
5
During the print, if the nozzle is too close to the bed to eject the filament, or if the nozzle is too far from the bed
and the filament is not adhered, press the [Adjust] button to adjust the height. Press number buttons and arrow
buttons as appropriate to adjust the height, and press the [Save & Return to Print] button to return to the Print
screen.
Reference
- The height adjusted during a print is applied only to the current print.
- Press the [↑] button to narrow the gap by lifting the bed, and press the [↓] button to widen the gap
by lowering the bed.
6 To cancel the print without completing the procedure, press the [Stop] button.
After the print is completed, the bed automatically falls to the lower section of the chamber and waits until it is
cooled down.
Caution
- The bed is hot. Thus, do NOT touch the bed and the output until the bed has cooled down.
To remove the output before the bed is cooled down, press the [Cancel] button and
wear protective gloves to take it out.
Reference
- For the information on how to remove an output, see “1. Output Checking” on Page 4-1.