![background image](http://html1.mh-extra.com/html/faac/s800h-sb/s800h-sb_manual_3228886008.webp)
7
a
a
x 1
A
B
90
90
0
90
90
0
90
90
0
a
a
a
a
x 1
EN
g
L
iSH
Fig.12
Fig.13
Fig.15
Fig.14
1) Take the gate to its open position.
2) Consulting the instructions in chapter 7.1, hydraulically release
the operator, using the key (Fig. 1 ref.
r
) on the release screw
(Fig. 12 ref.
a
)
3) On the operator, unscrew the cap (Fig.13 ref.A) of the closing
travel-limit screw (Fig.13 ref.
a
) and check if the screw is
completely tight.
4)
Unscrew the closing travel-limit (Fig.13 ref.
a
)
screw by
one turn (iMPORTANT FOR CORRECT COUPLiNg OF THE
PiNiON-MECHANiCAL RELEASE DURiNg iNSTALLATiON).
5) Turn the operator pinion with the supplied key,
in the gate
closing direction
as shown in Fig.14, up to the internal stop point
of the piston, and remove the key.
4.2 OPERATOR WITH MECHANICAL RELEASE
TRAVEL-LIMIT STOP
AT OPENING
TRAVEL-LIMIT STOP
AT CLOSING
6)
Without moving the pinion
, insert the supplied key on the
operator as shown in Fig.15, and make sure that it indicates 0
(ZERO) on the operator’s plastic panel (Fig.15 ref.
a
). If necessary
rotate the pinion.
( i M P O R T A N T F O R C O R R E C T C O U P L i N g O F T H E
PiNiON-MECHANiCAL RELEASE DURiNg iNSTALLATiON)
.
NOTE: if necessary, lightly screw the closing travel-limit screw.
INSERT THE KEY WITHOUT MOVING THE PINION
AND CHECK IF IT INDICATES ZERO
TURN THE KEY TILL REACHING THE MECHANICAL
STOP-POINT AND WITHDRAW IT FROM THE PINION
www.metalines.com