A
B
C
EN
g
L
iSH
NOTE: if necessary, lightly screw the closing travel-limit screw
7)
Remove the adjustment wrench, screw the plug of the travel
limit screw and grease the pinion.
8) Using the handles, insert the operator in the bearing case as
shown in Fig.7-8,
9) Close the gate.
10) Raise the operator with its handles (Fig.10 ref. A), inserting
the pinion in the grooved bush of the bearing case. To facilitate
the operation, slightly rotate the operator until coupling takes
place.
Fig.7
Fig.8
Fig.9
Fig.10
Fig.11
11) Place the supplied key under the operator, as shown in figure
10 ref. B, C
12) Insert and screw the fastening screws with groover and
washer as shown in Fig. 10 ref. C, in order to secure the operator
to the bearing case as shown in Fig. 11.
13) Open the gate and check if the opening travel-limit stop
is correctly positioned; if necessary, adjust the travel-limit stop,
referring to the instructions in chapter 5.
14) Close the gate and check if the closing travel-limit stop is
correctly positioned; if necessary, adjust the travel-limit stop,
referring to the instructions in chapter 5.
15) Hydraulically shut down the operator as per instructions in
chapter 7.1.
16) As described in the instructions for the control board, make
the electrical connections, taking care over encoder polarity.
17) Secure the cover of the bearing case with the supplied
screws.
www.metalines.com
