FAAC FSL700, Руководство пользователя

Страница: 13 / 32

13
Chain Connection - Rear Mount
Rear mount operators require the use of an endless idler assembly and twice as much chain. Approximately 1 foot of added open-
ing space is needed. Once the gate operator is securely bolted down, the chain may be installed for a rear mount system.
1. Adjust the chain idler sprocket inside the gate operator for a rear mount application. Remove the lower idler on the unused
side and move it to the upper idler hole on the chain side of the operator. Both chain idlers should be above/below each other.
2. Increase the cover chain slot on the chain side of the operator. (Side toward the gate opening)
3. Close the gate and mount an endless idler assembly near the back of the gate. The chain must extend beyond the back of the
gate.IMPORTANT: Only use an endless idler assembly with a safety guard to prevent pinch and entrapment points.
4. Adjust the height of the endless idler sprocket so the chain from the lower chain idler is level with the bottom of the endless
idler. (Approximately 11”) Make sure the chain will be in a straight line and same height as the lower idler sprocket.
5. Weld the bottom chain bracket to the end of the gate and level with the top of the endless idler sprocket. (Height depends
upon the size of the endless idler sprocket)
6. Weld the top chain brackets to the end of the gate and level with the top of the upper idler sprocket. (Approximately 15”)
7. Route the chain through the operator, over the upper chain idler, around and under the chain sprocket, and over the lower idler.
8. Route the lower chain under and around the endless idler assembly.
9. Connect the chain bolts to each end of the chain using the supplied master links. Connect the chain bolts to the chain brack-
ets. Adjustments to the chain length should be made now.
10. Tighten the chain using the chain bolts so the chain does not sag more than one (1) inch per 10 feet of travel. Do not over
tighten!
WARNING: DO NOT INSTALL this product unless all
safety standards are followed and all entrapment and
pinch points have been eliminated.