FAAC FSL700, Руководство пользователя

Страница: 10 / 32

10
TECHNICAL SPECIFICATION
FSL 700 Slide Gate Operator
The FAAC Model FSL 700 is an electro-mechanical vehicular slide gate operator. The direct drive 24V motor allows for smooth start
and stop operation, with easy to set limit switches. It has a built in battery backup system and 2 accessory power plugs. The adjust-
able chain idlers allow front, rear and post mount operation.
Input voltage 120 VAC (+5% -5%)
Power 500 W
Current 5 A
Motor voltage 24 VDC
Motor power 0.67 hp (0.5 KW)
Leaf max weight 1000 lb (454 Kg)
Leaf max length 40 ft (12 m)
AC accessory outlets 2 GFCI protected
AC accessory current 4 A
Gate speed 12 in/sec
Gearbox 15:1 fail safe
Use frequency 75 cycles/h
Operating temperature -4°F ÷ 131°F (-20°C ÷ +55°C)
Operator weight 125 lb (57 Kg)
Chain height - front mount 11 in (278 mm) from base
Chain type # 41
Gate Operator Location
Select a location for the gate operator to be installed prior to pouring the concrete pad. There are two ways to mount a slide gate
operator: the traditional front mount, or the rear mount method. Both methods have their advantages and will reliably open the gate.
The front mount method places the operator up front near the
flow of traffic and uses a single chain across the length of the
gate.
Avantages:
• Less chain is required for the application
• Does not require the use of an additional idler sprocket
• Less room is needed for the application
Disadvantages:
• The operator is up front near the flow of traffic allowing for
a vehicle to damage the operator more easily.
• The chain runs across the length of the gate allowing visi-
tors to see and possible tamper with it.
The rear mount method places the operator at the back of the
gate and uses a double chain with an additional idler sprocket.
Advantages:
• The chain is attached to the rear of the gate and is not vis-
ible when the gate is closed.
• The operator is in the back away from the flow of traffic for
added safety.
Disadvantages:
• Twice as much chain is required for this type of application
• The application requires the use of an additional idler
sprocket
Front Mount Method: Rear Mount Method
15 in
18 in
22 in
GATE OPERATOR INSTALLATION
Gate Operator Specifications