![background image](http://html1.mh-extra.com/html/faac/844/844_manual_3175704014.webp)
14
F
+
+
= Sequential obstacle detection
F
FORCE:
Adjusts Motor thrust.
= minimum force
= maximum force
OPENING DIRECTION:
Indicates the gate opening movement
and makes it possible not to change the
motor connections on the terminal bo-
ard.
= Rightward opening movement
= Leftward opening movement
STATUS OF AUTOMATED SYSTEM:
Exit from programming, save data, and
return to gate status viewing.
= Closed
= Now opening
= At "STOP"
= Open
= Pause
= "FAIL SAFE" error
= Now closing
= Now reversing
= Photocells tripped
Display
Function
Default
Display
Function
Default
5.5.2.
ADVANCED PROGRAMMING
To access ADVANCED PROGRAMMING, press key
F
and, as
you hold it down, press key
+
:
• If you release key
+
, the display indicates the name of
the first function.
• If you release key
F
too, the display shows the value of the
function that can be modified with keys
+
and
-
.
• If you press key
F
(and hold it down), the display shows the
name of the next function, and if you release it, the value
that can be modified with keys
+
and
-
is shown.
• When you reach the last function, press
F
to exit the program,
and the display resumes showing the gate status.
The following table shows the sequence of functions
accessible in ADVANCED PROGRAMMING:
ADVANCED PROGRAMMING
MAXIMUM TORQUE AT INITIAL THRUST:
The motor operate at maximum torque
(ignoring the torque setting) at start of move-
ment. Useful for heavy leaves.
= Active
= Disabled
NOTE: Status
will be displayed after two consecuti-
ve triggers of the safe input or two consecutive obstacle
detections from the inherent entrapment protection device
(encoder). In this status the operator will also set off the audio
alarm. Normal operation can only be resumed by breaking
the stop circuit or resetting power.
Fig. 33
5.5. PROGRAMMING
To program operation of the automated system, access the
"PROGRAMMING" mode with keys
F
,
+
and
-
on the cover.
Attention: before attempting to power up the system,
re-position the board's cover to avoid contact with high
voltage parts and to access the push-button keys on the
cover (Fig. 33).
BASIC PROGRAMMING
Display
Function
Default
FUNCTION LOGICS (see table of logics):
= Automatic
= "Stepped" automatic
= "Safety" Automatic
= Semi-automatic
= "Stepped" Semi-automatic
= Dead-man
= "B" Semi-automatic
= Mixed Log.(B opening / C closing)
PAUSE TIME:
This has effect only if automatic logic
was selected.
Adjustable from to
sec. in one-
second steps.
Subsequently, display changes to minu-
tes and tens of seconds (separated by a
point) and time is adjusted in 10-second
steps, up to the maximum value of
minutes.
E.g. if the display shows
, pause time
is 2 min. and 50 sec.
5.5.1.
BASIC PROGRAMMING
To access BASIC PROGRAMMING, press key
F
:
• If you press it (and hold it down), the display shows the name
of the first function.
• If you release the key, the display shows the value of the
function that can be modified with keys
+
and
-
.
• If you press
F
again (and hold it down), the display shows the
name of the next function, etc.
• When you reach the last function, press
F
to exit the program,
and the display resumes showing the gate status.
The following table shows the sequence of functions
accessible in BASIC PROGRAMMING:
Programming is divided in two parts:
BASIC
and
ADVANCED
.
+
-
F