EZG FHN9, Руководство пользователя

Страница: 21 / 46

1-800-417-9272 www.ezgmfg.com
Revision Number-001 01-01-2020 - Present
19
SERVICE & MAINTENANCE
THE BRAKE SYSTEM
The Foot Brake
When driving the Forklift, if you want to stop the Forklift immediately, take your right foot off the accelerator
pedal and press the brake pedal placed in the middle until the Forklift has come to a complete stop.
Warning: Do not press the accelerator pedal and the brake pedal at the same time, that will burn out
the electric component .
The braking moment of the two wheels in front of the Forklift can be regulated. If the braking is not quite
effective, you may adjust by means of steel cables. Tighten screw of steel cables appropriately. If one of the
wheel is tight and another wheel is loose, the loose wheel should be adjusted and tightened. Brakes must
be adjusted with great care by an experienced technician. The method to do so is as follows:
• Raise the front wheels of the Forklift.
• Remove the footrest.
• Adjust the screw of steel cables on the retainer.
• After adjusting the brake, turn the wheels to see if they are free.
• Simultaneously have another techincian press the brake pedal lightly.
• Turn the wheels to inspect the different braking between the two wheels. If one wheel is tight and another
wheel is loose, the brakes should be adjusted again.
• Have the technician press the brake pedal hard.
• Rotate the two wheels by hand, and wheels should not turn.
The hand brake (fig.5
The hand brake acts as the parking brake. Before carrying out any repair, inspection, or maintenance
operations, you should pull the hand brake. The hand brake is at the left side of the front of the Forklift. Pull
the hand brake control lever tightly to the inside and press the active button in the center of the hand lever,
push the hand lever forward, before releasing the hand lever. If the hand brake is too loose or too tight, it
needs to be adjusted. The adjusting method of the hand brake is as that of the foot brake.
Fig.4 - The Hydraulic Lifting System
1. The hand brake
2. The steering column locknut
Note: The Forklift cannot start when pulling the hand brake on.