5
Product Category
Step 7 — Install Modules
Figure 7 shows how to install a power module. The cable pass-
through module and AAP module are installed in the same way.
The TLP Pro 725C has three triple spaces available for installing
modules. Extron recommends that, if they are installed, retractors
should occupy one of the end spaces. There is no prefered order for
the power module, cable pass-through module, or AAP module.
If required, power modules must be purchased separately. See the
Extron website (
www.extron.com
) to select a power module that is
suitable for your location.
ATTENTION:
•
For units that are used in North America, only use AC power
modules that are UL Listed Model “Cable Cubby AC Power
Module”.
•
Pour les unités qui sont utilisées en Amérique du Nord, utilisez
seulement les modules d’alimentation secteur qui sont listés
UL, modèle « Cable Cubby AC Power Module ».
•
The unit is not UL Listed if it uses any AC power module other
than Model “Cable Cubby AC Power Module”.
•
L’unité n’est pas certifiée UL si elle utilise tout autre module
d’alimentation secteur autre que le modèle «Cable Cubby AC
Power Module ».
To install the power, cable pass-through, or AAP modules, follow
these instructions.
1.
Insert the module into the cable cubby (figure 7,
1
). Make sure
the mounting holes on the module line up with the holes on the
Cable Cubby enclosure.
If you are installing retractors, they should be secured using the
lowest level of mounting holes inside the touchpanel enclosure.
Cable pass-through, AAP, and power modules can be mounted at
at any height.
2.
Secure the modules with #6-32 Phillips head screws and star
washers.
CAUTION:
Risk of electric shock: To ensure proper
electrical grounding, use the provided grounding screws
and star washers.
ATTENTION :
Risque de décharge électrique: Afin
d’assurer une mise à la terre correcte, utilisez les fixations
de mise à la terre et les rondelles en étoile fournies.
3.
(Power module only) Run the cable or conduit to a convenient
junction box. Extron recommends the circuit be attached to a
junction box that is directly wired to the main circuit.
e
21-
525
-01
LF
21-
526-
01L
F
125
V~
12A
MA
X T
OTA
L
Insert the modules
into the Cable Cubby.
1
Secure the modules
using four of the
provided #6-32
pan-head mounting
screws and star washers.
2
Figure 7.
Installing a Module