Extron electronics TouchLink TLP Pro 725C NC, Руководство пользователя

Страница: 40 / 42

Reference Material
This section describes:
•
Network Port Requirements and Licensed Third-Party Software
•
Reset Modes
Network Port Requirements and Licensed Third-Party Software
For information about network port requirements and licensed third-party software for the
touchpanels described in this guide, please refer to the
Pro Series Control Product Network
Ports and Licenses Guide , which is available at www.extron.com .
Reset Modes
The touchpanels described in this guide have three reset modes that are initiated by pressing the
Reset
button:
•
Use Factory Firmware
(see below)
•
Reset All IP Settings (see below)
•
Reset to Factory Defaults (see following page)
•
Enable or Disable the DHCP Client
(see following page)
The
Reset
button is found on the base of the TLP Pro 725C (see figure 13 , B , on page 17).
Use Factory Firmware
This mode is used to boot up the unit with factory-installed firmware for a single power cycle
in the event of a firmware update that failed or incompatibility issues arising with user-loaded
firmware.
Activation
To start the
Use Factory Firmware
reset mode and replace firmware:
1.
Remove power from the touchpanel.
2. On the touchpanel, hold down the recessed
Reset
button (see figure 13 ,
B
) while
re-applying power to the unit. When power is restored, the Reset LED (
C
) lights. Hold the
Reset
button for a further 2 seconds before releasing it. The touchpanel enters factory
firmware mode.
3.
Upload new firmware to the unit as desired (see Updating the Firmware on page 29).
NOTE:
Do not continue to operate the touchpanel using the factory firmware
version. If you want to use the factory default firmware, you must upload that
version again (see
Updating the Firmware )
.
Result
The unit reverts to factory-installed firmware. Event scripting does not start if the unit is powered
on in this mode. All user files and settings such as drivers, adjustments, and IP settings are
maintained.
NOTE: To return the unit to the firmware version that was running prior to the reset,
cycle power to the unit.
TLP Pro 725C Series Touchpanels • Reference Material 30