Figure 22 shows how to mount the TLP Pro 725M. Mounting the TLP Pro 525M or 1025M is
very similar.
TOP
e
Back View
1
2
3
4
5
6
4
Figure 22.
Mounting the TLP Pro 725M to a Wall Box (left) and Mounting Plate (right)
1.
Install a junction box or wall box (see figure 20,
1
), following the instructions provided by
the manufacturer.
2.
Make sure you have the correct mounting plate for your touchpanel and fasten it to the wall
with the provided screws (
2
). Use the mounting holes that are appropriate to the junction
box you are using (see figure 21, on the previous page).
NOTES:
•
Extron provides four 3/4” #6-32 Philips pan head screws for mounting to US
junction boxes.
•
Extron provides two 16 mm M 3.5 Philips pan head screws for mounting to MK
junction boxes.
•
EU junction boxes are usually provided with their own screws.
3.
Run and connect cables to the back of the touchpanel (see
4.
Position the touch panel so that the mounting slots in the rear of the touchpanel align with
the hooks on the mounting plate. The TLP Pro 725M and 1025M mounting plate has four
hooks (
3
), one in each corner, top and bottom. The TLP Pro 525M mounting plate has two
hooks, one in each corner at the top.
5.
Move the touchpanel inwards so that slots move over the hooks.
6.
Move the touchpanel down so that touchpanel is seated securely on the hooks and the
tongue at the bottom of the mounting plate (
4
) is sitting in a groove in the bottom of the
touchpanel (see inset,
5
).
7.
Tighten the mounting screw (
6
) to fasten the touchpanel to the mounting plate.
figure 22
steps 3 through 7
TLP Pro 525, 725, and 1025 Series Touchpanels • Mounting
28
