SW USB Series • Installation
Installation, cont’d
2-4
SW USB Series • Installation
2-5
Use 2 mounting holes on
opposite corners.
(2) 4-40 x 3/16"
Screws
1U Universal Rack Shelf
Front false
faceplate
uses 2
screws.
HalfRackVersaToolsStandardShelf
1/2 Rack Width Front False
Faceplate
3
2
4
Mounting an SW USB switcher on a standard 9.5-inch
deep rack shelf
Furniture mounting
To mount the SW USB switcher under a desk, table, or podium,
use the optional MBU 123 VersaTools Mini Under-Desk
Mounting Kit (part #70-212-01), as follows:
1
.
If rubber feet were previously attached to the bottom of the
unit, remove them.
2
.
Remove the two screws from one side of the SW USB.
Retain the screws for possible later reassembly.
3
.
Attach one bracket to the side of the unit, using the
provided machine screws.
4
.
Circuit overloading
— When connecting the equipment
to the supply circuit, consider the effect that circuit
overloading might have on overcurrent protection and
supply wiring. Consider equipment nameplate ratings
when addressing this concern.
5
.
Reliable earthing (grounding)
— Maintain reliable
grounding of rack-mounted equipment. Pay particular
attention to supply connections other than direct
connections to the branch circuit (e.g., use of power strips).
Rack mounting procedure
1
.
If feet were previously attached to the bottom of the
switcher, remove them.
2
.
Mount the SW USB Series switcher on the rack shelf, using
two 4-40 x 3/16" screws in opposite (diagonal) corners to
secure the unit to the shelf (see the figures below and on
the next page).
3
.
Install blank panel(s) or other unit(s) on the rack shelf as
desired.
4
.
Install the shelf in the rack.
The following illustrations show examples of how the SW USB
can be mounted on different sized rack shelves.
HalfRackVersaToolsShelf
(2) 4-40 x 3/16"
Screws
Use 2 mounting holes on
opposite corners.
VersaTools Rack Shelf
1/2 Rack Width Front
False Faceplate
2
3
4
Mounting an SW USB switcher on a 3.5-inch deep
VersaTools rack shelf
