Extron electronics FOXBOX Rx DVI MM, Руководство пользователя, Страница: 34 / 50

Command and Response Table for SIS Commands (continued)
FOXBOX Tx / Rx • Remote Control 26
Command Function
SIS Command
(Host to Unit)
Response
(Unit to Host)
Additional description
Test pattern
NOTE: You must have a video input connected and the transmitter-Tx-to-receiver-Rx fiber cable connected for the receiver to output a
selected test pattern. The test pattern turns off if the input signal rate changes or is disconnected or if power is removed.
Output color bars 1J Tst1
]
Set the receiver to output the color bars
test pattern.
Output grayscale
2J Tst2
] Set the receiver to output the grayscale
test pattern.
Output alternating pixels
3J Tst3
] Set the receiver to output the alternating
pixels test pattern.
Turn test pattern off
0J Tst0
] Set the receiver to output the input video
(no test pattern is selected).
Show test pattern status
J
X1^]
Disable and enable return link
NOTE: The disable return link function is primarily used and recommended when the transmitting device is a FOX 500 DA6 and the
receiver is connect to any of outputs 2 through 6 on the DA.
Disable return link
66*0*0# Rle*0*0
] Disable link 2.
Enable return link to transmitter
66*0*1# Rle*0*1
] Enable link 2 ( default ).
Show return link status
66*0# 0*
X1*]
Video shutdown delay
NOTES:
•
This command mutes the output for a variable period of time when the unit detects a change in the input pixel clock.
0.5 second is the default. This feature can prevent glitches when the input video signal resolution changes.
•
Front panel DIP switch 2 must be on (up) for this command to function.
Enable video shutdown 3* X1&
#
Dly
X1&]
Mute the output for an interval of
X1&
.
Example:
3*3# Dly3
] Mute the output for 0.75 second.
View video shutdown
3#
X1&]
The video shutdown interval is
X1&
.
Plus mode transmission
NOTE: The Plus mode commands are valid for FOXBOX Tx DVI Plus units only, with a firmware revision of 3.00 or higher (see the
Show
Firmware version (
Q
) SIS command, on the next page).
Enable Plus mode 81*1# Plus1
]
Turn on Plus mode ( default ).
Disable Plus mode
81*0# Plus0
] Turn off Plus mode.
View Plus mode
81#
X1*]
Show Plus mode status.
NOTE:
X1^ = Test pattern
0
= none
2
= grayscale
1
= color bars
3
= alternating pixels
X1& = Video shutdown interval
0
= 0 seconds (off)
4
= 1 second
1
= 0.25 second
5
= 1.25 second
2
= 0.5 second (default)
6
= 1.5 second
3
= 0.75 second
X1* = Enable or disable
0
= disable 1 = enable (default)