Extron electronics FOXBOX Rx DVI MM, Руководство пользователя, Страница: 30 / 50

FOXBOX Tx / Rx • Remote Control 22
Unit-initiated Messages
When a local event occurs, such as an equipment power-up, the unit responds by sending
a message to the host. The unit-initiated messages are listed below:
(c) Copyright 20 yy
, Extron Electronics FOXBOX Tx VGA, V x . xx , 60- xxx - xx
]]
- or -
(c)
Copyright 20 yy
, Extron Electronics FOXBOX Rx VGA, V
x
.
xx
, 60-
xxx
-
xx ]]
- or -
(c)
Copyright 20 yy
, Extron Electronics FOXBOX Tx VGA/YUV, V x . xx , 60- xxxx - xx
]]
- or -
(c)
Copyright 20 yy
, Extron Electronics FOXBOX Tx DVI, V
x
.
xx
, 60-
xxx
-
xx ]]
- or -
(c) C
opyright 20 yy
, Extron Electronics FOXBOX Rx DVI, V x . xx , 60- xxx - xx
]]
- or -
(c) C
opyright 20 yy
, Extron Electronics FOXBOX Tx DVI Plus, V
x
.
xx
, 60-
xxxx
-
xx ]]
- or -
(c)
Copyright 20 yy
, Extron Electronics FOXBOX Rx DVI Plus, V x . xx , 60- xxxx - xx
]]
The connected unit issues the appropriate copyright message (above) when it first powers
on. V
x . xx is the firmware version number; 60- xxxx - xx is the part number of the connected
unit.
Reconfig
]
The unit sends the Reconfig message whenever the video input signal to the transmitter is
changed.
1Lnk
X1(
•2Lnk
X1(
•RGB
X1(
•Aud
X1(]
The unit sends the status message whenever a change in the fiber link, video, or audio
connection occurs.
Dip
X$X$]
The unit sends the DIP switch position message whenever a change in the DIP switch
settings occurs on the receiver.
Error Responses
When the switcher receives a valid SIS command, it executes the command and sends a
response to the host device. If the switcher is unable to execute the command because the
command is invalid or it contains invalid parameters, the switcher returns an error response
to the host. The error response codes are:
E10 — Invalid command
E11 — Invalid preset number
E13 — Invalid parameter
E14 — Invalid command for this configuration
Timeout
Pauses of 10 seconds or longer between command ASCII characters result in a timeout.
The command operation is aborted with no other indication.