2-5
IPL T PCS4 • Installation and Rear Panel
PRELIMINAR
Y
LAN port cabling
•
For 10Base-T (10 Mbps) networks, use a Category 3 or better cable.
•
For 100Base-T networks, use a Category 5 cable.
•
Use a
straight-through cable
to connect to a switch, hub, or router.
•
Use a
crossover cable
to connect directly to a PC. Wire the connector as
shown in the tables below.
Clip Down
1
1&2 3&6 4&5
7&8
2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
RJ-45
connector
Twisted
Pairs
Straight-through Cable
(for connection to a switch, hub, or router)
End 1
End 2
Pin
Wire Color
Pin
Wire Color
1
white-orange
1
white-orange
2
orange
2
orange
3
white-green
3
white-green
4
blue
4
blue
5
white-blue
5
white-blue
6
green
6
green
7
white-brown
7
white-brown
8
brown
8
brown
Crossover Cable
(for direct connection to a PC)
End 1
End 2
Pin
Wire Color
Pin
Wire Color
1
white-orange
1
white-green
2
orange
2
green
3
white-green
3
white-orange
4
blue
4
blue
5
white-blue
5
white-blue
6
green
6
orange
7
white-brown
7
white-brown
8
brown
8
brown
RJ-45 connector wiring
Configuring the LAN port
You need to configure the LAN port before using it. You can configure the
settings via either SIS commands or the embedded Web pages. See
chapter 4,
Web Page-based Setup and Control
, or chapter 5,
SIS
™
Programming
and Control
, for details.
LAN port factory defaults:
•
Link speed and duplex:
Auto Detect
•
Unit IP address:
192.168.254.254
•
Subnet Mask:
255.255.0.0
•
Gateway IP address:
0.0.0.0
•
DHCP:
Off
5
UID # label
—
Contains the unique User ID number (MAC address) of the
unit (for example, 00-05-A6-00-00-01). On the PCS4, the MAC address is on
a label in the upper-right corner of the rear panel.
6
Serial number label
— Contains the serial number of your PCS4 unit.
im Vertrieb von
CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
