Extron electronics AXP 64 C AT, Руководство пользователя, Страница: 32 / 53

AXP 64 C AT • Dante Configuration and Operation 24
Configuring the AXP 64 C AT in Dante Controller
Use a standard Ethernet cable to connect the AXP 64 C AT to a Dante network via the rear
panel AT port (see
figure 2
,
K
on page 5).
Device Name
Multiple devices on the same Dante network can present difficulty in identifying individual
devices. To avoid confusion and difficulty, ensure the following steps are taken:
• Connect devices to the Dante network one at a time.
• Rename each device before making audio connections in Dante Controller.
• Rename each device with a unique and meaningful identifier.
•
Rename each device before the next device is connected to the Dante network.
ATTENTION:
• It is essential that a Dante device be named before audio subscriptions with
other devices are established. Existing subscriptions are removed when a device
is renamed.
• Il est essentiel qu’un appareil Dante soit nommé avant l’établissement des
abonnements audio avec d’autres appareils. Les abonnements existants sont
supprimés lorsqu’un appareil est renommé.
In Dante Controller, a device can be renamed to identify the device on the audio network.
The default device name of the AXP 64 C AT consists of the model name, followed by the
last six characters of the Dante interface MAC address (for example,
FOX3AT-1b6c78
). In
addition to renaming the device, individual Transmitter (Tx) and Receiver (Rx) channels can
be renamed.
The Dante device name must be set before making any connections to other devices on the
Dante network. Renaming a device after making connections removes existing connections
to and from that device. Refer to
Renaming the AXP 64 C AT in Dante Controller on
page 25 for renaming procedure.
Receiver and Transmitter Names
In addition to renaming a device, individual transmitter and receiver channels can be
renamed in Dante Controller. Rename transmitter and receiver channels to reflect the
location of the device or the purpose of the transmitter or receiver. Ensure transmitter and
receiver channels are renamed before making audio connections between devices. Refer to
Renaming a Receiver or Transmitter on page 27 for renaming procedure.
ATTENTION:
• It is essential that a Dante device be named before audio subscriptions with
other devices are established. Existing subscriptions are removed when a device
is renamed.
•
Il est essentiel qu’un appareil Dante soit nommé avant l’établissement des
abonnements audio avec d’autres appareils. Les abonnements existants sont
supprimés lorsqu’un appareil est renommé.