Extreme Networks Summit WM20, Руководство пользователя

Страница: 45 / 270

Performing the First-Time Setup of the Summit WM Controller
Summit WM20 User Guide, Software Release 4.2
45
3 To select a port, click it.
Port configuration allows for the explicit state of the administration state for each interface. By
default, data interface states will be enabled. If they are not enabled, you can enable them each of
them individually. A disabled interface does not allow data to flow (receive/transmit).
4 Type the following:
●
IP address – The IP Address of the physical Ethernet port.
●
Subnet mask – The appropriate subnet mask for the IP address, which separates the network
portion from the host portion of the address (typically 255.255.255.0).
●
MTU – The Maximum Transmission Unit or maximum packet size for this port. The default
setting is 1500. If you change this setting and are using OSPF, be sure that the MTU of each port
in the OSPF link matches.
NOTE
If the routed connection to an AP traverses a link that imposes a lower MTU than the default 1500 bytes, the
Summit WM Controller and AP both participate in MTU discovery to automatically learn the correct MTU and
adjust their settings accordingly. At the Summit WM Controller, MTU adjustments are tracked on a per AP basis.
5
Select a
Function
from the drop-down list:
●
Host Port – Specifies a port for connecting Wireless APs with no OSPF routing function on this
port.
●
Third-Party AP Port – Specifies a port to which you will connect third-party access points.
● Router Port
– Specifies a port that you want to connect to an upstream, next-hop router for OSPF
route advertisement in the network.
NOTE
For OSPF routing on a port, the port must be configured as a router port.
6 To enable management traffic, select the Mgmt checkbox. Enabling management provides access to
SNMP (v2, get), SSH, and HTTPs management interfaces.
NOTE
This option does not override the built-in protection filters on the port. The built-in protection filters for the port,
which are restrictive in the types of packets that are allowed to reach the management plane, are extended with
a set of definitions that allow for access to system management services through that interface (SSH, SNMP,
HTTPS:5825).
7 To enable the SLP protocol, select the SLP checkbox.
Wireless APs use this port for discovery and registration.
8 To allow Multicast Support , select Enabled from the drop-down list.
9 To save your changes, click Save .
Setting up Static Routes
It is recommended that you define a default route to your enterprise network, either with a static route
or by using OSPF protocol. A default route enables the Summit WM Controller to forward packets to
destinations that do not match a more specific route definition.