Extreme Networks Altitude 3550, Руководство по развертыванию, Страница: 21 / 32

Altitude 3550 Access Point Deployment Guide
21
5 Power Tap Installation
The installation of the AP3550 Power Tap (Part No. 15729) requires the services of licensed and trained
electricians. The end user is solely responsible to ensure the unit is installed and maintained by
properly certified personnel. Additionally, the end user is responsible the unit is installed and
maintained in full compliance of local codes and standards.
WARNING!
DO NOT open an installed or operating Power Tap unit. Always make sure the unit is not energized before opening
an installed or operating unit.
Pre-Installation Guidelines
Before attempting to install a Power Tap, refer to the following guidelines:
●
DO NOT open an installed or operating unit. Ensure the unit is not energized before opening an
installed or functioning unit.
●
A Power Tap installation requires the services of licensed and trained electrician.
●
Proper unit earth grounding is required to ensure safe and proper operation. Earth grounding must
comply with all specific or regional electrical codes and regulations.
●
Opening the Power Tap exposes high voltage wiring, and creates a shock hazard. Care must be
taken to avoid introduction to the unit interior of any foreign object and/or fluids that would
facilitate a shock hazard.
●
The instructions provided herein are intended to provide useful installation guidance, and offer
insight into best practices. Adherence to this guide, and the instructions herein do not ensure
compliance with specific or regional electrical codes and regulations.
●
In all cases, specific or regional electrical codes and regulations shall govern the installation of this
product.
●
Installation and maintenance of this product in compliance with specific or regional electrical codes
and regulations is the sole responsibility of the end user.
Power Tap Installation
Before installing the Power Tap, ensure your have familiarized yourself with the pre-installation
guidelines described in
“Pre-Installation Guidelines” on page 21 .