Extreme Networks Altitude 3550, Руководство по развертыванию, Страница: 10 / 32

Mounting Kit Assembly and Use
Altitude 3550 Access Point Deployment Guide
10
3 Install 4 short binder head screws in the 4 slots, 2 each on left and right sides of the tilt bracket.
These can be tightened during this phase of the assembly. Once deployed in the field, the 4 screws
should be loosened slightly to allow the AP3550 to be tilted to level, then re-tightened.
4 If sliding to a small pole diameter, up to 2 ½ inches in diameter, place the pole clamps into the slots
of the bracket assembled in step 3.
The pole clamps can be installed into inner or outer slots to adjust for pole diameters of various
sizes.
5 Install 2 long binder head screws through the two holes of one clamp into the other clamp. Direction
is not important.