Extreme Flight YAK-55SP, Инструкция по эксплуатации

Страница: 9 / 20

9
12.
Next slide the wing into position and check alignment with fuselage and
horizontal stab. Measure to insure wing is positioned properly and then use a fine
tipped felt marker to mark the area where the covering will need to be removed to
insure a wood-to-wood bond between the wing and fuselage.
13. Remove the wing from the fuselage and use an old soldering iron or sharp hobby
knife to remove the covering from the center of the wing. Use some denatured
alcohol to remove any remaining ink.
14. Slide the wing into position just a few inches short of its proper location. Mix up
some 30 minute epoxy and apply to the exposed wood at the center of the wing
with an epoxy brush.