Extreme Flight YAK-55SP, Инструкция по эксплуатации

Страница: 20 / 20

20
34.
Run you fuel lines from the tank to the engine. We usually drill through the
fuselage to route fuel lines and help keep them out of the propeller.
35. Secure the radio compartment hatches with 4 screws each, installed 1at each
corner.
36. Apply decals, and that’s it! Assembly is done!
Set-up
According to designer Jeremy Chinn the CG range is 5”-5.75” from the leading edge of
the wing measured at the root. Jeremy says the ideal 3D CG is at 5.25”. Below are his
recommended rates and exponential preferences. You may wish to start with a bit more
exponential than this as the control surfaces are extremely effective!
High Rates Low Rates Expo
Elevator 50 degrees 25 degrees 20-40%
Rudder 50-60 degrees 30 degrees 30-50%
Ailerons 50 degrees 30 degrees 20-40%
Thanks again for your purchase of the Extreme Flight RC Yak-55SP Profile ARF. We
hope this airframe provides you with all of the 3D thrills you are looking for and that you
have as much fun flying yours as we have had with ours.
See ya at the flying field!