7
7.
Locate the rudder, composite control horn and base, aluminum bracket, tailwheel
wire, wheel and 2 collars. Remove the covering from the slot for the rudder
control horn and insert the horn into the base and into the slot. Trace around the
base with a fine tipped marker and remove the covering from this area. Glue the
horn and base into position with 30 minute epoxy. You will need to trim and sand
the bottom of the horn to prevent it from protruding through the other side of the
rudder. Be sure to scuff the portion of the horn that will glue into the rudder for
best adhesion.
8.
Slide a small wheel collar over the tailwheel wire and insert the tailwheel wire
into the hole in the aluminum mounting bracket. Use a set of pliers to bend the
wire to 90 degrees as shown, making sure the bend is perpendicular to the portion
of the wire where the tailwheel will mount.
9.
Drill a hole in the bevel of the rudder to accept the wire just below the bottom
hinge. Slot the bevel to allow the vertical portion of the wire to be embedded.
Trial fit, and then secure with 30 minute epoxy, making sure to thoroughly coat
the wire and balsa. Use a piece of strapping tape to reinforce this area. Once dry
slide the tailwheel onto the wire and secure with a small wheel collar.
Содержание YAK-55SP
Страница 1: ...YAK 55SP Profile ARF Instruction Manual Copyright 2008 EXTREME FLIGHT RC Ltd ...
Страница 14: ...14 ...