Extreme Flight Muscle Bipe ARF, Инструкция по сборке

Страница: 24 / 38

18. Insert 2 24" Extreme Flight 20AWG servo extensions into the center wing
section and secure it to the cabane struts with 4 4mm socket head cap bolts.
Secure the servo extension to the struts with a nylon cable tie or Velcro wrap.
19. Next lets set up our rudder control system. If using a gas 70-76cc twin it is
absolutely imperative that you install your rudder servo under the canopy
hatch and use the supplied pull-pull cable system. Failure to do so will result
in difficulty achieving the correct center of gravity. If running the heavier
radial engine, mount your servo in the rear of the model and fabricate your
linkage from the supplied pushrod, ball links and 3mm hardware. PLEASE
NOTE: Mount the ball link and conical spacer on the interior side of the EF
1.5" servo arm as shown to prevent interference with the elevator linkages.
Assemble the pull-pull cable linkage as shown in the following series of
pictures by inserting the end of the pull-pull cable into one of the aluminum
crimp tubes. Insert the cable through the hole in the brass fitting and back
through the crimp tube. Loop the cable one more time through the crimp tube
and pull it tight. Use a crimping tool or set of side cutters to carefully crimp
the tube in multiple places, taking care not to cut through (continued)
23