Extreme Flight Muscle Bipe ARF, Инструкция по сборке

Страница: 8 / 38

3. Test fit the control horns and baseplate into the surface and make sure
everything fits properly. Use a high quality epoxy to glue the horns into the
surfaces. I've started using the Loctite Hysol products and glue gun which
makes this process so much faster with less clean up required and less waste. I
like the slow set EA 9462 for this particular procedure. It allows plenty of time
for gluing all of the control horns into place in one sitting.
I first apply glue to both slots, then to both sides of each control horn below the
baseplate. Once the glue has been applied insert the horns into their slots and
press into place firmly against the control surface. Wipe away any excess glue
with a paper towel soaked with denatured alcohol. Set aside to dry. Repeat
this process for all control surfaces.
7