Extraflame DIADEMA ACS IDRO, Руководство пользователя

Страница: 21 / 36

21 ENGLISH
reset
allows the user to reset all values modifiable by the user to the default values.
CONTrOls prOCeDUre
Š
press key 6.
Š proceed by pressing key 2 until
user menu
is displayed.
Š Confirm using key 6.
Š press key 2 until
reset
" is displayed.
Š press keys 4-5 to select
on
and press key 6.
Š
"
Done
" will appear on the display to confirm.
low
The following menu allows the user to adjust the percentage of pellet feed.
if the stove has functioning problems owing to the quantity of pellets, adjust pellet feeding directly from the control board.
The problems correlated to the amount of fuel can be divided into 2 categories:
NO FUel:
Š the stove can never develop a suitable flame, tending to remain very low even at high power.
Š at minimum power the stove tends to almost switch-off taking the stove into “
no pellets
” alarm condition.
Š when the stove displays the “
no pellets
” alarm, there may be non-burned pellets inside the burn pot.
exCess FUel :
Š
the stove develops a very high flame even at low power.
Š
the panoramic glass is very dirty, obscuring it almost totally.
Š
the burn pot tends to become encrusted, blocking the holes for air intake due to the excessive pellet feed, as it is only burned partially.
The adjustment to be performed is in percentages. Therefore changing this parameter will lead to a proportional variation of all stove
feeding speeds. Feeding is from -30% to +20%.
CONTrOls prOCeDUre
Š
press key 6.
Š proceed by pressing key 2 until
user menu
is displayed.
Š Confirm using key 6.
Š press key 2 until "
pellet
" is displayed.
Š Use keys 4-5 to increase (4) or decrease (5) the load during the WOrk stage.
Š press key 1 several times to confirm and exit the menu.
set CHrono
This stage is used to program when the generator automatically turns on and off.
The factory setting for set Crono is disabled on the generator.
The chrono allows the user to program 4 time spans within a day to use every day of the week.
the switch-on and switch-off time can be set in every time slot, along with the days of use of the programmed time slot and the
desired water temperature (65 - 80°C).
The setting of the current day and time is essential to ensure the chrono operates correctly.
reCOmmeNDaTiONs
Before using the chrono function, set the current day and time. Therefore check that the points listed in the “ Set clock ” sub-chapter have been
followed, so that the chrono function works. aside from programming it, activate it as well.
The ignition and switch-off times must be within the arc of one day, from 0 to 24 and not over several days:
CORRECT INCORRECT
switch-on time 07:00
switch-off time 18:00
switch-on time 22:00
switch-off time 05:00
Example: