Extraflame DIADEMA ACS IDRO, Руководство пользователя

Страница: 17 / 36

17 ENGLISH
operation anD loGiC
iGnition
Once the points listed previously have been checked, press key 1 for three seconds to ignite the stove.
15 minutes are available for the ignition phase. after ignition and having reached the control temperature, the stove interrupts the ignition
phase and passes to sTarTiNg.
startinG
During the start-up phase, the stove stabilises combustion, increasing it progressively, to then start ventilation and pass on to WOrk.
work
During the work phase, the stove reaches the set power; see following item.
set power aDjustment
set the operating power (from 1 to 5).
power 1 = minimum level - power 5 = maximum level.
set H2o temperature aDjustment
set the boiler temperature between 65 - 80°C .
pump operation
The pump activates water circulation when the temperature of the water inside the stove reaches 60°C. as the pump always functions above
60°, an always open heating area is recommended to make product functioning homogenous, preventing overheating blocks. Normally this
area is defined “safety zone”.
burn pot CleaninG
at pre-set intervals the stove performs burn pot cleaning, switching the machine off.
When the cleaning phase is finished, the stove will re-start automatically and continue its work going back to the power level selected.
moDulation and H-off
as the water temperature approaches the set point, the boiler starts to modulate automatically bringing itself to the minimum power.
if the temperature increases beyond the set point, it will automatically switch off indicating
H-off
and will automatically go back on when
the temperature drops below the set point.
switCH-off
press key 1 for three seconds.
When the operation has been performed, the appliance automatically enters the switch-off phase, blocking the supply of pellets.
The flue gas exhaust motor will remain on until the stove temperature has dropped below the factory parameters.
re-iGnition
The stove can only be re-ignited automatically or manually when the cooling cycle conditions and the preset timer have been satisfied.
J
no iGnition
first iGnition CoulD even fail as tHe auGer is empty anD is not always able to loaD tHe burn pot
witH tHe requireD amount of pellets on time to reGularly start tHe flame.
if tHe problem oCCurs after only a few montHs workinG, CHeCk tHat routine CleaninG stateD in
tHe stove booklet, Has been CarrieD out CorreCtly.
Do not use any inflammable liquiDs for iGnition!
Do not allow tHe baG of pellets to Come into ContaCt witH tHe boilinG Hot stove DurinG tHe fillinG pHase!
in tHe event of Continuous no iGnition, ContaCt an autHoriseD teCHniCian.
it is forbiDDen to use tHe applianCe witHout tHe DiviDer (see tHe
fiGure to tHe siDe). its removal jeoparDises tHe safety of tHe
proDuCt anD immeDiately voiDs tHe warranty perioD. in tHe Case
of wear or Deterioration request after-sales assistanCe for
replaCement of tHe part (replaCement tHat is not unDer Guarantee
as tHe Component is subjeCt to wear).
BUrN pOT Upper DiviDer