381270 v1.2 04/02
17
TILT STAND
The tilt stand can be placed either in the locked stand position for flat surface use or in
the hinged position for hanging use.
1. For use on a flat surface, lift the
stand to approximately a 55
degree angle and push in until
the stand locks in the holding
hole.
2. To hang the meter, squeeze the
legs of the stand and remove it
from the meter. Turn the stand
180 degrees and replace in the
holder. The stand will now swing free over the top of the meter.
BATTERY REPLACEMENT
Caution:
Do not use non-rechargeable batteries (alkaline, carbon-zinc, etc.) with the
optional AC power adaptor. The AC power adaptor may be used when the optional
rechargeable Ni-Cd batteries are installed.
1. Lift the tilt stand and remove the
two screws.
2. Lift the two battery covers up to
remove them.
3. Replace the six batteries.
Observe the proper polarity as
indicated in the compartment.
MULTISCOPE BATTERY TUBES
Contained within this package you will find two hollow cardboard tubes. The purpose
of these tubes is to hold the batteries in place in the battery compartment. Directions
for proper installation: Remove the battery cover screw and then remove the battery
cover itself. Insert three AA 1.5V batteries into each tube (observing proper polarity).
Now insert the full tube into the battery compartment (observing proper polarity).
Replace the battery cover and then replace the screw.
FUSE REPLACEMENT
1. Lift the tilt stand and remove the two screws.
2. Lift the two battery covers up to remove them.
3. Remove the batteries.
4. Lift to remove the fuse cover.
5. Replace any defective fuse with a fuse of the same type.
