DT40_60_100M-en-GB_v1.0 8/17
8
Programming Menu
1.
Long press
to open the programming menu
2.
Use the MEAS button to step through the options
3.
Use the (+) and (-) keys to make changes
4.
Use the MEAS button to exit the menu
5.
See table below for the program options
1
ON: OFF:
For distance measurements: Set Laser to
default ON/OFF. Use + key to select.
2
For all other measurements: Set Laser to
default ON/OFF. Use + key to select.
3 CAL. 0
Use +/- keys to offset display by ±7mm
4 bP. on/oFF
Use +/- keys to set beeper default ON/OFF
5
bL. On/oFF
Use +/- keys to set backlight default
ON/OFF
6 od. On/oFF
Unused mode
Distance Measurements
Single Distance Measurements
1.
Momentarily press the MEASURE key to switch the meter ON;
Dashes (- - -) will appear on the display.
2.
If the Laser point is already ON, go directly to step 3 below. If
the Laser point is not ON, press MEASURE to switch it ON.
3.
Aim the meter and short press MEASURE to take a reading.
4.
You can elect either to have the Laser always ON or to turn ON
only when MEASURE is pressed. Go to the Programming Menu
section of this manual for details.
