Extec I-C13 Impactor, Руководство по эксплуатации и техническому обслуживанию

Страница: 43 / 292

Ver: IC13-EN-10567 Commissioning and Operation Page 33
I-C13 Impactor
4.7 Tracking Procedure
The operator must be fully trained in the operation of this equipment. When tracking, the
operator must be in a position to have an all round view of the operation. A banks man or marshal
should assist where this is not possible.
Ensure the site is clear of non essential personnel. Erect barriers around the area and post
warning signs where site conditions warrant this.
Loading/ unloading must only be carried out on firm flat ground.
Note: This equipment must never be tracked on gradients that are more than: 10 degrees
Port to Starboard or 20 degrees Front to Back. The machine must always be on flat,
solid ground when operating in its normal mode.
When engine is running at speed No.1, the machine can be moved to desired position on site
by following the procedures in the order listed below:
17: Press button "
interlock
on
".
18: Activate levers to raise
front jacking legs.
19: Activate levers to raise
rear jacking legs.
Where a recirculation
conveyor is fitted, the
jacking leg levers are
located in the hydraulic
control cabinet.
20: Activate levers to raise
front jacking legs.
21: Activate levers to raise
rear jacking legs.
22: Jacking legs fully raised 23: Press button "
tracks on
".