14
X-Cite
®
Optical Power Measurement System User Guide
035-00390R rev. 3
7.1.2
When the
‘STORE’
button is pressed the display shows the
‘MEM’
icon and a
number (starting at 1), that corresponds to the number of stored readings. The
number will increment each time
‘STORE’
is pressed and the measurement will
be stored.
7.1.3
Stored readings cannot be recalled on the XR2100. The stored readings can be
downloaded and viewed when connected to the X-Cite
®
Control Panel. Refer to
section 8
for X-Cite
®
Control Panel Operation/data log.
7.1.4
After downloading the stored data into the X-Cite
®
Control Panel, the stored
reading numbers will start at 1 again.
7.2 Favorite Wavelengths
7.2.1
If the same few wavelength settings will be used again and again they can
be stored as favorites. Up to 5 favorites can be selected, all favorites must
be selected during one wavelength selection session
. The session is over
when the LCD screen defaults back to displaying a power reading indicated by a
watts unit or a percentage unit. Only the wavelengths saved will be stored as
favorites. The selected session will time-out after idling for 4 seconds, so it is
important to know your favorites prior to starting the selection session.
7.2.2
To manually store your favorite wavelengths into the XR2100, use the
▲
or
▼
button to scroll through and select desired wavelength.
7.2.3
Press the
‘X-Cite
®
CAL’
button, the display will start to flash, once flashing press
the
‘STORE’
button to store this wavelength as a favorite. To select another
Note:
GUI Operation/Advanced Power Snapshot to store directly
onto the computer.
