existing keyless entry or alarm system to activate the remote start operation. If the
Pink/Black wire receives a Negative pulse, the unit will start the vehicle's engine,
provided that all safety circuits are in the proper status. After the engine has been started
by remote control, another Negative pulse on the Pink wire will turn the unit off, stopping
the engine.
The Pink/Black wire can be connected to an available auxiliary output of an existing Re-
mote Security System, and the unit's remote control may also be used to activate the
remote start operation.
The White wire is a programmable output to the
vehicle’s exterior parking lights to visually confirm system operations; +12 Volt or - Nega-
tive output may be selected by the Black jumper next to the doorlock port. Connect the
White wire to the vehicle's 12 Volt parking light circuit as shown in the accompanying
18-Gauge White Wire:
( +/- ) Parking Light Output
Connection Recommended.
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
12345
12345
12345
12345
12345
12345
12345
12345
12345
12345
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
1234567
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
123456
1234
1234
1234
1234
1234
1234
1234
1234
1234
1234
1234
12
12
12
12
Dash Board
Lights
Control
Module
Parking Lights
Light
Switch
White Wire
Typical Parking Lights Connection
Dimmer
Note: output
polarity is
selectable
Jumper
Parking Lights
When you leave your vehicle, simply set the climate controls for what you would
like to have operating upon remote starting - the heater, defroster or air conditioning.
Valet Mode
The unit may be placed into a “valet mode” which prevents the remote start feature
from being activated. Valet Mode should always be used when you do not wish for the
remote starter to be operated, such as when you have your vehicle serviced or leave it with
someone else. The Valet Switch, a small push-button, is used (check with the installer for
the location of this switch).
•
At any time simply press the Valet Switch for 5 seconds; the Status Light will light steady,
to indicate Valet Mode, and stay illuminated continuously while the system is in Valet
Mode.
Upon entering the vehicle place the ignition key in the switch and turn it to the "On" posi-
tion, and then deactivate the unit. Do not turn the key to the "Start" position!
Deactivation
•
Stepping on the brake pedal will turn the engine off.
•
To stop the engine by remote control, simply press the same button(s) used to start it.
•
Otherwise, after the preset programmable time the unit
will turn the engine off.*
•
Opening the hood will turn the engine off. If the hood is open when an activation attempt
is made, the unit will only flash the parking lights 4 times, but will not start the engine.
•
Pressing the Valet Switch will also stop the engine.
* The preset engine running time is 10 minutes, and 20, 30 and 40 minutes are optional.
5
24
