22
User Programmable Features (cont’d)
Feature #15 - Alarm Trigger Duration
30 Seconds (press LOCK to program)
60 Seconds (press UNLOCK to program)
90 Seconds (press TRUNK to program)
120 Seconds (press START to program)
This feature selects the period of time for which the system sounds the siren (and/
or horn) and flashes the lights when triggered.
Caution: Before lengthening the
Alarm Duration you should always check and determine if there are any local
anti-noise or nuisance ordinances in your area.
Feature #16 - Arming Delay
3 Seconds (press LOCK to program)
15 Seconds (press UNLOCK to program)
30 Seconds (press TRUNK to program)
45 Seconds (press START to program)
This selects how long the alarm waits to monitor trigger zones after arming.
Feature #17 - Open Door Warning Upon Arming
On (press LOCK to program)
Off (press UNLOCK to program)
When this feature is turned on, if one of the vehicle’s doors is open at the time that
the system is armed via the controller or transmitter, the siren will chirp 3 times and
the parking lights will flash 3 times, instead of once.
Feature #14 - Ignition Activated Override
On (press LOCK to program)
Off (press UNLOCK to program)
This feature allows an activated system to be overridden and disarmed by simply
turning the ignition switch on within 10 seconds of the alarm triggering� After 10 sec-
onds, the Emergency Override must be performed�
Feature #13 - SecureCode
DEFAULT - 1 Press
SecureCode is a unique patented feature which allows you to select the number of
Valet Switch presses in two stages, instead of “1 press”, which would be required in
order to perform an Emergency Override� If any of the three anti-carjacking features
are utilized, a customized SecureCode would also be required to turn it off once it is
fully activated� SecureCode operation is described on page 10�
To custom program a new SecureCode:
Step 1
Access user feature #13 (follow the steps on page 15)�
Step 2
Within 10 seconds slowly press and release the transmitter’s LOCK button
the number of times equal to the desired SecureCode for stage 1, allow the system to
respond to each transmitter button press with a siren chirp before pressing the button
again. A few seconds after the final button press, the system will chirp confirming the
total number for stage 1�
Step 3
Configure stage 2 of the SecureCode by pressing and releasing the LOCK
button again equal to the number of times desired for the stage 2� The system will
confirm as it did for stage 1.
NOTE:To start over, press the valet button 13 times again.
Содержание AL-2075-3DB-L
Страница 28: ...Back Cover Color cover is in a separate file...