Excalibur AL-2075-3DB-L, Руководство по эксплуатации

Страница: 26 / 28

26
Installer Programmable Features (cont’d)
This device complies with part 15 of the FCC Rules� Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation�
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules�
These limits are designed to provide reasonable protection against harmful interference in a residential installation� This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications� However, there is no guarantee that interference will not occur in a particular
installation� If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna�
- Increase the separation between the equipment and receiver�
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected�
- Consult the dealer or an experienced radio/TV technician for help.
Warning! Changes or modifications made to this equipment not expressly approved by the part responsible for compliance could void
the use’s authority to operate the equipment
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment.
Such modifications could void the user’s authority to operate the equipment.
Feature #17 Low Temp Crank Extender
0ms (press LOCK to program)
200ms (press UNLOCK to program)
300ms (press TRUNK to program)
400ms (press START to program)
When the vehicle’s interior temperature is below freezing, this feature adds extra crank time to the
base timing (see installer feature #7)� It applies to tachless modes only (installer feature #3)�
Feature #20 Low Current / Motorcycle Mode
On (press LOCK to program)
Off (press UNLOCK to program)
This feature, when on, reduces the system’s current draw by as much as 40% while the alarm is
armed� It causes the starter interrupt output to only operate when the ignition is turned on and re-
duces the frequency of the “armed” flashing status light significantly. This is ideal when the system
is to be used on vehicles that have limited battery capacity and/or may sit for extended periods
without charging the battery�
Feature #19 - Horn Relay Function
Horn Output (press LOCK to program)
Ignition (press UNLOCK to program)
Trunk Release (press TRUNK to program)
Pulse After Start (press START to program)
The primary function of this second relay, is to operate the vehicle’s existing horn; either in con -
junction with the electronic siren, or in place of the siren� Using both a siren and the horn creates
an extremely effective security system.
Feature #18 - Arm, Disarm or Additional Channels
Arm / Disarm (press LOCK to program)
Arm / Channel 5 (press UNLOCK to program)
Ch 4 Pulse / Disarm (press TRUNK to program)
Ch 4 Pulse / Ch 5 Pulse (press START to program)
Ch 4 Latch / Disarm (press LOCK & UNLOCK to program)
Ch 4 Latch / Ch 5 Pulse (press TRUNK & START to program)
The system has outputs designed for arming and/or disarming a factory-equipped security
system� These wires may be used instead to provide further system outputs, which are remotely
operated by the controller� These outputs are in addition to the 2nd channel and 3rd channel out-
puts� As shown in the programming assignment, the arm, disarm, channel 4 and channel 5 are
programmable as various combinations� The Channel 4 Latch function will reset when the remote
button(s) is pressed again, the ignition is turned “on”, or the system looses main power