Excalibur AL-2075-3DB-L, Руководство по эксплуатации

Страница: 11 / 28

11
PIT-STOP FEATURE
This feature allows you to leave your engine running for quick errands� To use this
feature, have the engine running normally from the ignition switch and your foot off
the brake pedal. Press the Valet Switch twice; the parking lights will flash to confirm.
Turn the key off and the engine will remain running for the programmed run time�
XL PIT STOP : Press the Valet Switch 6 times instead of 2 & the engine will run for 12
hours� Ideal for commercial applications such as refrigeration & cleaning vehicles�
LAST DOOR ARMING
See user feature #9� When this feature is enabled, the siren/horn will chirp once
when all of the doors are closed� It will then start a 30 second countdown (fast
flashing status light). After 30 seconds, the system will arm. During the 30 second
arming delay, if a point of entry is opened, the countdown will pause until all entry
points are closed again� Turning ON the ignition key will cancel the last door arming
sequence until the key is turned off and the doors are all closed once again�
AUTOMATIC REARMING
This automatically rearms the alarm if the system is disarmed from the remote�
(see user feature #10 to enable)� When disarmed by remote, the system will start a
90 second countdown (fast flashing status light) to arm the system. This is useful if
the controller may accidentally disarms the system when it’s kept in a purse or pocket
where other items could potentially press the buttons� ENHANCED AUTO REARM
allows you to cancel the countdown by pressing UNLOCK a second time within
5 seconds of the first press to disarm the alarm.
Security System Features
MANUAL TRANSMISSION STARTING
Remote starting with a manual transmission requires that you ensure the gear
selector is in NEUTRAL� There are 2 available methods�
METHOD #1 - 3D MOTION SENSOR:
This system is equipped with a 3D motion sensor built into the antenna� Whenever
remote start is activated, the sensor is monitored for vehicle movement� If the vehicle
moves just a few inches when the engine is cranking, it will instantly turn the engine
off� This safety feature allows you to enjoy remote start without performing reservation
mode as described below�
METHOD #2 - RESERVATION MODE:
For extra safety, installer feature #11 can be turned on which requires you to perform
a setup procedure that ensures the transmission was left in neutral when you park
your vehicle� This must be performed each time you leave your vehicle to use remote
start later� To do so, follow these steps:
1) With the engine running via the ignition switch, hold the brake pedal, apply the
parking brake, then release the brake pedal�
2) Use the transmitter as if you were activating remote start (default: press START
twice). The status light will start to flash slow.
3) Turn off the ignition key and exit the vehicle, the engine will continue running.
4) Press LOCK on the transmitter� The engine will shut down (unless turbo timer is
on) and the status light will flash every 2 seconds (ready to be remote started).
NOTE: Manual transmission starting is canceled if you enter the vehicle after
performing the setup procedure.
Other Remote Start Features (cont’d)