Excalibur AL-1850-EDPB, Руководство по эксплуатации

Страница: 5 / 24

5
Controller & Transmitter Functions (cont’d)
ChAnnEL 3: Press and hold the “TRUNK” & “ “ buttons for 3
seconds
YOUR SYSTEM WILL ACTIVATE ThE ChAnnEL 3 •
OUTPUT
UPOn RECEIVIng COnFIRMATIOn FROM YOUR •
SYSTEM, ThE COnTROLLER WILL ShOW ThE ChAn-
nEL 3 ICOn
(1-way transmitter: press anD holD the “||” & “|||”
buttons for 3 seConDs)
ChAnnEL 4: Press and hold the “LOCK” & “TRUNK” buttons for 3
seconds
YOUR SYSTEM WILL ACTIVATE ThE ChAnnEL 4 •
OUTPUT
ThERE IS nO 2-WAY COnFIRMATIOn FOR ThIS •
FUnCTIOn
(1-way transmitter: press anD holD the loCk &
“||” buttons for 3 seConDs)
The engine will run for the preset run time (see user feature #17).
Run Time Extender • : Press the “ ” button one time during remote start to
restart the engine run timer The timer will restart at “0:00”
nOTE: This can only be used once per remote start cycle. The controller will also give you
“run time expiration” warning (2 chirps) 1 minute before the remote start cycle ends.
If you decide not to drive your vehicle, you can turn off the remote start using •
the same method to turn it on (Default = press “ ” twice in 5 seconds)
nOTE: if user feature #17 is programmed for 1 press, the 1st press = Run Time Extender so
an additional press is required.
Upon entering the vehicle during remote start mode, turn the ignition key to •
the “On/RUn” position ( nOT START!! ) When you press the brake pedal, the
remote start will turn off allowing the ignition key to take over.
*
*
*
ChAnnEL 5: Press and hold the “UNLOCK” & “ “ buttons for 3
seconds
YOUR SYSTEM WILL ACTIVATE ThE ChAnnEL 5 •
OUTPUT
ThERE IS nO 2-WAY COnFIRMATIOn FOR ThIS •
FUnCTIOn
(1-way transmitter: press anD holD the un-
loCk & “|||” buttons for 3 seConDs)
*