Excalibur AL-1850-EDPB, Руководство по эксплуатации

Страница: 16 / 24

16
User Programmable Features
To custom program a new SecureCode:
Step 1 Follow Steps 1 to 4 in the previous “Programming Features” section to access
“feature #1”.
Step 2 Within 10 seconds slowly press and release the controller or transmitter’s
“ arm/lock ” button the number of times equal to the desired SecureCode for stage 1,
allow the system to respond to each controller/transmitter button press with a siren
chirp before pressing the button again. A few seconds after the final button press, the
system will chirp the horn/siren confirming the total number for stage 1.
Step 3 Configure stage 2 of the SecureCode by pressing and releasing the “ disarm/
unlock ” button the number of times desired for the stage 2. The system will confirm
as it did for stage 1.
Feature #2 - Last Door Arming
Off (press “ lock ” button to program) - DEFAULT
On w/o Doors Locking (press “ unlock ” button to program)
On w/ Doors Locking (press “ trunk ” button to program)
“Last Door Arming” has the system automatically arm itself every time you exit the
vehicle (the complete operation is described on page 8). This feature turns that op -
eration on or off, and with options of having Last Door Arming operate with or without
also locking the doors when the system does arm
Feature #1 - SecureCode
DEFAULT - 1 Press
SecureCode is a unique patented feature which allows you to custom select the num -
ber of Valet Switch presses in two stages, instead of a single “1 press”, which would
be required in order to perform an Emergency Override. If any of the three anti-car -
jacking features are utilized, a customized SecureCode would also be required to turn
it off once it is fully activated. The SecureCode operation is described on page 10.
Feature #3 - Automatic Rearming
Off (press “ lock ” button to program) - DEFAULT
On w/o Doors Locking (press “ unlock ” button to program)
On w/ Doors Locking (press “ trunk ” button to program)
Enhanced Auto Rearm (press “ start ” button to program)
“Automatic Rearming”, described on page 9, rearms the alarm if accidentally dis -
armed Options are to have Automatic Rearming operate with or without also locking
the doors when the system does rearm Enhanced auto rearm allows you to cancel
the rearming sequence by pressing unlock a 2nd time after disarming.
Feature #4 - Starter interrupt Functions
Alarm Only (press “ lock ” button to program) - DEFAULT
Anti-Grind Only (press “ unlock ” button to program)
Alarm & Anti-Grind (press “ trunk ” button to program)
Automatic (press “ start ” button to program)
Alarm Only - The Starter Interrupt is operable whenever the alarm is armed
Anti-Grind Only - The Starter Interrupt is operable whenever remote start is on
Alarm & Anti-Grind - This setting engages starter interrupt when the alarm is armed
AND when the system is in remote start mode. This prevents the starter from grinding
if the user accidentally turns the key to “START” during remote start.
Automatic - This will cause the Starter Interrupt output to automatically engage 90
seconds after the ignition switch is turned “off”, and after disarming.