Exalt Communications, Inc.
r-series
Installation and Management Manual
5000007 (ETSI)
34
2007-02-12 (draft)
Configuration and Management
This section describes the command line interface (CLI) and Exalt graphical user interface
(GUI).
Telnet into the Command Line Interface (CLI)
Use a Telnet connection to access the CLI in the Exalt Digital Microwave Radios. Use the CLI to
set key parameters on the system.
Connect to the Radio in a Telnet Session
Make the Telnet connection to the radio through the Ethernet port. Use Windows and perform
the following steps:
1.
Open a command prompt or MS-DOS prompt (
Start>Run
).
2.
Type C:\>Telnet
<IP Address>
at the command line:
The default IP address is
10.0.0.1
The accessing computer must be on the same IP subnet as the radio.
Telnet
Use Telnet when prompted to enter the administration level login and password. The default
administration login is
admin
and password is
password
. It is recommended that the default
administration password be reset by performing a radio reset (see Reset to Critical Factory
Settings on page 27).
Figure 10 shows the three menu choices available after log in.
Figure 10
CLI main menu
Select 1 or 2 to display the Configuration or Status menus, respectively. Select 3 to exit the
session. The following selections can be made on all screens:
•
0 = back to previous screen
•
9 = help