Exalt Communications, Inc.
r-series
Installation and Management Manual
5000007 (ETSI)
24
2007-02-12 (draft)
completes, the LED is solid when no alarm conditions are present, and flashes continuously if
alarms conditions are detected. The LED remains in this state until another boot up or until alarm
conditions change.
RESET Button
There is only one external control on the r-Series system, a button labeled “RESET” which is
located on the Power Injector. This button performs two functions: critical system parameter
reset and summary alarm information.
Use the reset function if the IP address and/or passwords are lost. Use the following steps to
perform a critical parameter reset:
1.
Remove power from the radio by disconnecting the AC adapter from the power injector.
2.
Hold down RESET button on the power injector while applying power.
Hold the RESET button down through the whole power cycle and monitor the
DATA+POWER left LED on the power injector. Release the RESET button only after the
LED is in the steady state (45 to 60 seconds).
3.
Release the RESET button.
The following configurations are reset on the radio:
•
IP address = 10.0.0.1
•
IP mask = 255.0.0.0
•
IP gateway = 0.0.0.0
•
Administration password = password
•
User password = password
•
Endpoint Identifier = Radio B
A flashing left DATA+POWER LED on the power injector indicates that alarm conditions exist
on the radio. To access summary alarm information during normal operation, press and hold the
RESET button. The following is status for the left the DATA+POWER LED while holding the
RESET:
•
Solid on is a link alarm (link is down or errored)
•
Flashing indicates a minor alarm (does not affect traffic)
Power
The radio requires a DC power source within specifications. DC can be provided from a DC
battery source, central lab/rack supply, or from the supplied AC adapter.
Read this section completely before applying power.