Exabyte VXA-2, Руководство по эксплуатации продукта, Страница: 42 / 90

32
P
RODUCT
M
ANUAL
1009541
Chapter 4 T
ROUBLESHOOTING
2.
2. 2.
2. Make sure the tape drive is installed properly on the bus, described in
Chapter 2 . In particular, check the following:
4
Is the tape drive set to a unique SCSI ID?
4
Is a terminator installed at the physical end of the SCSI bus? Try another
terminator.
4
Is the IDE/ATAPI configuration set correctly? If the tape drive is the only
device on the cable, make sure that the IDE/ATAPI configuration jumper
is set to Cable Select (the default) or to Master. If there are two devices
on the cable, set the first device to Master and set the second device to
Slave. Or, set both devices to Cable Select.
Note: If the tape drive is the only device on the bus, or if it is configured as
Master, Exabyte recommends connecting the tape drive at the end of
the IDE bus.
4
Is there a broken cable or defective connector? Try another, known-good
cable.
4
Is the cable correctly oriented and firmly seated on the tape drive
connector?
3. 3. 3. 3. Reboot your system.
Many SCSI and IDE host bus adapters display a list of detected devices
during the system boot process. Make sure that your tape drive is listed.
If your tape drive is not detected by the host bus adapter, check the
following:
4
Is there a broken cable or defective connector? Try another, known-good
cable.
4
Is the cable connector correctly oriented and firmly seated on the tape
drive connector?
4
Try another known good device in the same location on the bus.
4
If there are other devices on the same SCSI or FireWire bus, remove
them. Reboot the system and see if your tape drive is detected.
Reconnect the other devices to the bus one by one, rebooting the system
after each addition.
Important
If you have an external tape drive, make sure that it is powered on
before restarting the system.