Exabyte VXA-2, Руководство по эксплуатации продукта, Страница: 22 / 90

12
P
RODUCT
M
ANUAL
1009541
Chapter 2 I
NSTALLATION
Connect the power cable and mount the drive in the enclosure
1.
1. 1.
1. Connect the power cable.
Locate the enclosure’s internal power cable and connect it to the tape
drive’s power connector, as shown in Figure 2-4 or Figure 2-5 . The
enclosure’s power cable connector must be an AMP 1-480424-0 series, or
equivalent.
For the pin assignments of the tape drive’s power connector, see Table 8-7
on page 57 .
2.
2. 2.
2. Mount the tape drive in the drive bay.
Slide the tape drive into the bay. Ensure that no cables are caught or
crimped between the tape drive and the chassis. Using the screws provided
with the tape drive, secure the tape drive in the drive bay using one of the
screw mounting combinations (see Figure 2-10 ).
Caution
To avoid damaging the tape drive, follow these precautions:
4
Use only the M3
×
0.5
×
4 mm Phillips screws.
4
Ensure that the chassis is not distorted. (Alignment to the horizontal or vertical
plane should not exceed
±
10°.)
4
Ensure that no objects (screw heads, cables, or adjacent devices) are pressing
against the frame.
4
Do not use a combination of the two sets of mounting holes.
4
Do not obstruct the tape drive’s ventilation slots (top and rear).
Figure 2-6 Screw mounting configurations (internal model)
Side
Mounting
Bottom
Mounting